Cookies

We use analytics cookies to see which pages help people plan their build, so we can improve them. No ads, and we don't sell your data. You can change this any time under Cookie settings. Privacy policy

Chat on WhatsApp
ARCHITECTURAL-DRAWINGS

Electrical, Plumbing and Mechanical (MEP) Drawings for a House in Ghana [2026 Guide]

What MEP drawings are, what a Ghanaian house needs (wiring and the board, water tanks and pumps, the septic tank and soakaway, air conditioning), how big each part should be, and how to get a set made from your floor plan and signed by a registered engineer.

GhanaHousePlanner Team
11/15/2026
7 min read
MEP drawings Ghanaelectrical drawings house Ghanaplumbing drawings Ghanaseptic tank size Ghanasoakaway GhanaAC size bedroom Ghanahouse wiring Ghana

Electrical, Plumbing and Mechanical (MEP) Drawings for a House in Ghana

Your architect's drawings show the walls, doors and windows. They don't show where every socket goes, how thick the cable to the kitchen should be, how big the septic tank must be, or where the AC's outdoor unit hangs. Those are the MEP drawings: mechanical, electrical and plumbing. Without them, your electrician and plumber decide on site, and you pay for the changes later.

GhanaHousePlanner now makes all three sets from your floor plan: MEP drawings for your house.

The electrical set

For every room, the points it needs, and the circuits that feed them:

▸Lighting layout for each floor: lights by the room's size, a fan in the bedrooms and living room, switches beside each door (a bathroom's outside its door), two-way switches on stairs and halls
▸Power layout: sockets where you'll use them (by the TV, either side of the bed, along the kitchen worktop), outlets for the cooker, water heaters, ACs and the pump
▸Single-line diagram: the meter, main switch, RCDs and every circuit with its breaker and cable size
▸Schedules: each circuit's load and cable, checked for current and for voltage drop over its real length; the house's maximum demand, and whether it needs single- or three-phase from ECG

Backup power is planned in, not added later: tell us inverter, solar or generator, and the lights, fridge and living-room sockets go on an essential section that stays on when the power goes.

The plumbing and drainage set

▸Water supply for each floor, with pipe sizes worked out from the fittings each pipe feeds
▸Storage: an overhead tank for a day's water (about 120 litres a person) and an underground sump for two more days, with the pump sized to fill the tank in an hour. GWCL supply is on and off in many areas; this is why.
▸Soil and waste: every WC, basin, shower and sink connected, upstairs bathrooms down a stack. If an upstairs bathroom isn't over a wet room, the stack has to come down through a bedroom or living room: we flag it, so you can move the bathroom while it's still a drawing.
▸Drains outside: inspection chambers at every junction, falling at 1 in 40, with the depth of each
▸Septic tank and soakaway, sized to BS 6297 (or the connection to a public sewer where there is one)
▸Rainwater: gutters and downpipes, to the drain or a harvesting tank

How big is the septic tank?

The formula: 180 litres for each person, plus 2,000 litres, and never less than 2,720 litres, in two chambers.

HousePeopleSeptic tank
2 bedrooms52,900 L
3 bedrooms73,300 L
4 bedrooms93,700 L

The soakaway depends on your soil. A percolation test (a hole, filled with water, timed as it drains) gives the figure; until you have one, we size it for a moderate soil and the drawing says so plainly.

The mechanical set

▸An air conditioner sized for each room: about 1 HP for a typical bedroom, 1.5–2 HP for a living room, from its floor area, windows and the people using it

▸Outdoor units on a side or back wall, not on the front of the house, with the refrigerant and condensate pipes and the sleeves to build into the blockwork now
▸Extract fans in bathrooms without a window, and the kitchen hood

You can plan for AC now and buy the units later: the pipes, sleeves and outlets go in during the build, when it's cheap.

Checked against each other

The three sets are made from the same plan, then checked together. Our MEP check lists what doesn't fit and what to do: a socket too close to the sink, a shower without its water-heater circuit, an AC without an outlet, a drain under the house. You fix it on paper, not with a chisel.

Reviewed and signed by an engineer

The sets are designed by our engine and checked by our rules; that's not the same as an engineer's signature. Every sheet says "for engineer's review" until one reviews it. Ask for a review on the Drawings page: a registered engineer checks your set, marks it up and signs it, and their name and registration print on the sheets.

The signature belongs to the plan they signed. Move a wall or change a choice, and the sheets stop printing it until the new version is reviewed, so a signed drawing always matches what was signed.

For your engineer, contractor and QS

▸PDF sheet sets with schedules, for the site
▸DXF, one file a floor on standard E-, P- and M- layers, for AutoCAD, BricsCAD or LibreCAD
▸IFC: the house with its MEP, for Revit and other BIM tools
▸Counted and measured: every point counted and every cable and pipe run measured, for the bill of quantities

How to get yours

1Design your house with the AI design chat, or upload the plan you have
2Open Drawings & MEP and tick the sets you want, with your choices (cooking gas or electric, the water heaters, backup power, a sewer or a septic tank)
3Run the MEP check, then download the sets
4Ask a registered engineer to review and sign them

More about the drawings: architectural and structural drawings for your house.

Ready to Start Your Construction Project?

Use our advanced cost calculator to get accurate estimates for your building project in Ghana

Related Articles

3D House Renders in Ghana: Every Room, a Walkthrough Video and a 360° Tour of Your House [2026]

See your house before it's built: a photograph of every room and a walkthrough video, from a photo or PDF of your floor plan, an ArchiCAD or Revit IFC, an AutoCAD DXF, or your 3D model. What you get, what to upload, the price, and how architects and developers use it.

GhanaHousePlanner Team
11/12/2026
6 min read
Read More

Architectural & Structural Drawings in Ghana 2026: From 2D Floor Plan to 3D House Model and Permit-Ready Sheets

Turn your 2D floor plan into 3D house views, architectural sheets, and structural layouts. Learn what each drawing includes, why dimensions matter, and how to prepare for architect/engineer validation in Ghana.

GhanaHousePlanner Team
2/15/2026
9 min read
Read More